Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Air Filter on the KTM Duke

Model: Ktm Duke 390
Part: Air filter

Video tutorial

Let's see how to replace the air filter on the KTM Duke. Place the bike on a stand, remove the passenger seat by unlocking the key lock. Once removed, you can also take off the rider's seat to access the air filter cover.

Using a cross screwdriver, unscrew the six screws securing the cover and remove it. To remove the old filter element, operate the two levers that hold it in place. Replace the filter with a new one; you might take the opportunity to install a more open model that can improve engine airflow, securing it with the tabs.

Close the cover and secure it with the six screws, then reposition the two seats. If installing a freer filter, run the engine for about ten minutes to allow the ECU to adjust to the new installation.


Updated on 20 August 2026 by ScegliAuto


Related tutorials

Replacement of Air Filter on KTM Duke 250/390 2017
Replacement of Air Filter on KTM Duke 250/390 2017
Duke 390 Descriptive guide for replacing the air filter on a 2017 KTM DUKE 250/390. Obtain an air filter KTM p. N.90106015000. Position the motorcycle on the …
How to Replace the Air Filter in a KTM Duke 390
How to Replace the Air Filter in a KTM Duke 390
Duke 390 As shown in this tutorial, replacing the air filter in the KTM Duke 390 is an extremely simple and quick operation. First, remove the passenger seat,…
How to Replace the Air Filter on a KTM Duke 390?
How to Replace the Air Filter on a KTM Duke 390?
Duke 390 .. Replacing the air filter on the KTM Duke 390 is an extremely simple and quick task. First, open the passenger.. …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos