Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you set the clock on the Kymco KRV 200?

Model: Kymco Krv 200
Part: Clock

Video tutorial

To set the clock of the Kymco KRV 200, you need to insert the ignition key into the ignition switch: once the dashboard is turned on, you can hold down the MODE and ADJ buttons located below the instrument panel. In this way, you will notice that the hours will be flashing and can be changed by repeatedly pressing the ADJ button; now pressing the MODE button, you will notice that the minutes will also start flashing.

These can also be changed by repeatedly pressing the ADJ button, and finally turning off the dashboard.


Posted on 9 March 2025 by ScegliAuto


Related tutorials

How to set the time on the display of the Kymco KRV 200 dashboard
How to set the time on the display of the Kymco KRV 200 dashboard
Krv 200 Today's video tutorial will show us how to adjust the time on the display of the instrument panel of the Kymco KRV 200 scooter. First, we put the sco…
How to Reset the Service on a Kymco KRV 200 Scooter
How to Reset the Service on a Kymco KRV 200 Scooter
Krv 200 In this tutorial, you will see how to reset the service on a Kymco KRV 200 scooter, a very simple and quick operation to perform only after completin…
How to Replace the Air Filter on the Kymco KRV 200
How to Replace the Air Filter on the Kymco KRV 200
Krv 200 To replace the air filter on the Kymco KRV 200, lift the seat by unlocking the latch to access the under-seat compartment. At the front, you will fin…

How to Replace the Front Headlamp Bulb on a Suzuki GSX-R 600

Today's instructions will show you the steps to remove and replace the front headlamp bulb on the Suzuki GSX-R 600 motorcycle. First, place the bike on a stand and begin by removing the plastic cover protecting the bulb, located behind the headlamp and the instrument cluster; then disconnect the electrical connector and unclip the metal spring, as shown in the video. At this point, remove and replace the bulb with a new one of the correct type and fitting; then refit the bulb and turn on the ignition to check its operation!

Watch the video!


by ScegliAuto

More videos