Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The steps outlined in this guide will show us how to adjust the rear brake of the Kymco Super 8 150 scooter. First, we put the scooter on the center stand and start adjusting the cable from the adjuster located at the bottom, next to the rear wheel; then we screw and adjust the rear brake, making sure that the braking is improved and that the lever travel is reduced. If the braking does not improve, it will be necessary to check the wear of the brake pads or shoes, replacing them with new ones if necessary.

Posted on 6 April 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Shoes on the Kymco Super 8 150
How to Replace the Rear Brake Shoes on the Kymco Super 8 150
Super 8 150 Follow this guide to remove and replace the rear brake shoes on the Kymco Super 8 150 scooter. First, place your scooter on the centre stand and begi…
Replace the Front Brake Pads on a Kymco Super 8 150
Replace the Front Brake Pads on a Kymco Super 8 150
Super 8 150 Here are the instructions to remove and replace the front brake pads on the Kymco Super 8 150 scooter. First, place your scooter on the centre stand …
How do you replace the clutch of the Kymco Super 8 150?
How do you replace the clutch of the Kymco Super 8 150?
Super 8 150 To replace the clutch of the Kymco Super 8 150, you need to loosen the screws that secure the transmission cover, which is located near the rear whee…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos