Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
What we see in this video is a procedure suitable for those with basic mechanical knowledge: if we don't feel up to it, let's definitely rely on a good mechanic before making a mess that we might regret. First, let's proceed with the disassembly of the variator, removing the 12 reverse size bolts that secure the cover, being careful, as some bolts may fall during disassembly. Clean the residue of the old balancing mass (present on the internal components). Inspect the clutch, checking the gaskets, shoes, and bearings, which we will lubricate with specific grease for high temperatures. Using a 19 socket wrench to remove the rear pulley, clean the CVT belt and check for wear. It is recommended to use quality products, avoiding generic greases; check the direction of rotation of the components before reassembly.

Posted on 21 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery in a Kymco Xciting S 400i Scooter?
How to Replace the Battery in a Kymco Xciting S 400i Scooter?
Xciting 400 Replacing the battery in a Kymco Xciting S 400i scooter is an extremely simple and quick task. First, ensure the key is not inserted for safety, then…
How to Reset the Oil Service on the Kymco Xciting 400 Scooter?
How to Reset the Oil Service on the Kymco Xciting 400 Scooter?
Xciting 400 In this tutorial, you will see how to reset the oil service on the Kymco Xciting 400 scooter, a very simple and quick operation to perform only after…
How do you replace the air filter of the Kymco Xciting 400?
How do you replace the air filter of the Kymco Xciting 400?
Xciting 400 In order to replace the air filter of the Kymco Xciting 400, you need to loosen the screws that secure the filter cover, located on the left side of …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos