Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Headlight Bulb on a Kymco People 150

Model: Kymco People 150
Part: Headlight bulb

Video tutorial

Today, we will see how to remove and replace the headlight bulb on a Kymco People 150. First, remove the screws found under the handlebars: then also remove the front screw to take off the upper plastic along with the headlight. Next, disconnect the electrical connector of the bulb and remove the rubber protective cap; simply unclip the metal spring to extract the bulb and replace it with the new one, ensuring it has the same fitting (in this case, type H4). Refit everything by applying the reverse procedure!


Updated on 27 March 2026 by ScegliAuto


Related tutorials

How to Replace the Exhaust on Kymco People 150?
How to Replace the Exhaust on Kymco People 150?
People 150 You can replace the exhaust installed on the Kymco People 150 by loosening the screws that secure it to its mounts located near the rear wheel on the…
How to Replace the Oil Filter on a Kymco People 150?
How to Replace the Oil Filter on a Kymco People 150?
People 150 To replace the oil filter on a Kymco People 150, access the underside of the scooter, just in front of the rear wheel. Here you will find the oil dra…
How to Change the Engine Oil on the Kymco People 150?
How to Change the Engine Oil on the Kymco People 150?
People 150 To change the engine oil on the Kymco People 150, loosen the drain plug located at the bottom of the transmission casing on the right side of the sco…

How to set the clock on a Yamaha V-Star 1300?

To set the clock on a Yamaha V-Star 1300, press and hold the RESET button and the SELECT button upwards, after turning on the ignition by turning the key. Once done, the hours will start to flash, allowing you to adjust them using the arrows above and below the SELECT button. When the correct hours are set, hold the RESET button, and the minutes will start to flash: these can now be adjusted in the same manner, before turning off the ignition.

Watch the video!


by ScegliAuto

More videos