Do it yourself
Frequently asked questions about cars and motorcycles

Model: Kymco Like 150i
Part:

Unscrew the screws related to the front windscreen and remove it. Unscrew the lower screws securing the support bars of the removed windscreen, then unscrew the visible screws of the front fairing. At this point, using a small plastic wedge or a flat-head screwdriver, pry in the gap between the two parts of the front fairing, as shown in the video. Once done, you will have revealed all the other screws related to the light and fairing that you can easily unscrew, then remove everything. Proceed in reverse for reassembly.

Updated on 8 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Like 150i Before you begin, position your Kymco Like 150i on its centre stand. Start by removing the seat and under-seat panel by unscrewing the fixing bolts. …
Like 150i To replace the levers on the Kymco Like 150i, you need to loosen the screws that secure the front panel of the fairing: once this panel has been remo…
Like 150i To replace the belt on the Kymco Like 150i, first loosen the screws securing the cover near the rear wheel on the left side of the bike. Once the cov…

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos