|
Do it yourself
| |||
| ||||
Model: Kymco Ak 550
To replace the front brake pads on the Kymco AK 550, loosen the central pin that secures the pads inside the caliper. Use a socket spanner to remove the pin. Once it is removed, you can extract the pads from inside the caliper and replace them with new spare parts. After the new pads have been installed inside the caliper, secure everything by inserting and tightening the pin. After installation, check the correct functioning of the brake.
Updated on 28 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Ak 550
In order to replace the rear brake pads of the Kymco AK 550, you need to loosen the screws that secure the brake caliper to its housing, so that you …
Ak 550
To replace the rear brake pads of the Kymco AK 550, you need to loosen the screws that hold the caliper to the corresponding disc, so that it can be …
Ak 550
In this tutorial, you will see how to replace the rear brake pads on the Kymco AK 550 scooter, a very simple and quick operation. First, position you…
|
How to Service the Piaggio Vespa GTS 300
This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.091
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
