Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Turn Off the Oil Warning Light on a Kymco

Model: Kymco People Gt 300i
Part: Service warning light

Video tutorial

To reset the orange warning light indicating the service menu, follow these steps: turn on the ignition (do not start the engine). The display in the centre of the dashboard will show "service" and the orange warning light in the top right will be illuminated.

Locate the two buttons on the display: "mode" and "adjust". To turn off both the display indication and the orange warning light, press and hold both buttons simultaneously for 3 seconds. Then, turn off and on the ignition to check that the warning lights have been turned off.


Updated on 15 May 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil and Oil Filter on the Kymco People GT 300i
How to Change the Engine Oil and Oil Filter on the Kymco People GT 300i
People Gt 300i The process of changing the engine oil and oil filter on the Kymco People GT 300i takes just a few minutes and requires no special tools. First, plac…
How to Change the Transmission Oil on Kymco People GT 300i
How to Change the Transmission Oil on Kymco People GT 300i
People Gt 300i This guide provides instructions on how to replace the transmission oil on the Kymco People GT 300i scooter, following these simple steps. First, pla…
Engine Oil Change for Kymco People GT 300i
Engine Oil Change for Kymco People GT 300i
People Gt 300i In this video tutorial, you will learn how to change the engine oil on a Kymco People GT 300i. First, position your scooter on the centre stand and u…

How to Replace the USB Socket on the Benelli TRK 502?

To replace the USB socket on the Benelli TRK 502, loosen the screws securing the left side panel of the motorcycle, located just below the handlebars: once this panel is freed, you can remove it and locate the USB socket connector. By disconnecting this connector, you can pull the socket out of its housing: then connect the new socket to the connector, inserting it into its housing. After installation, check that the socket works by reinstalling the panel.

Watch the video!


by ScegliAuto

More videos