Do it yourself
Frequently asked questions about cars and motorcycles

How to Bleed the Brake System of the Kymco GP125

Model: Kymco Gp125
Part: Checks and maintenance

Video tutorial

This guide shows how to bleed the brake fluid system of the Kymco GP125. After securing the vehicle and protecting the upper fairing with rags, remove the two screws securing the brake fluid reservoir cap and take off the covers. Using an 8 mm spanner, loosen the bleed valve on the front caliper and install the drain hose.

Operate the brake to allow fluid to flow from the system. Remove the brake caliper, fully compress the piston, and clean it with an appropriate spray.

Refit everything in position and, if necessary, top up the fluid. Check the proper functioning of the brakes before hitting the road.


Updated on 28 May 2026 by ScegliAuto


Related tutorials

Gp125 You can change the oil of the Kymco GP125 gearbox by loosening the drain plug of the transmission casing, which is located at the rear of the bike ne…

How to Change the Engine Oil on a BMW R1200T?

To change the engine oil on a BMW R1200T, follow these steps. Ensure the bike is on a level surface and the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew it to fully drain the used oil. Once drained, remove and replace the oil filter, ensuring to clean the mounting surface thoroughly. Install the new filter and screw the oil drain plug back in. Fill the engine with new oil through the filler cap until reaching the recommended amount, checking the level with the dipstick if necessary. Secure both caps tightly. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Watch the video!


by ScegliAuto

More videos