Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco X Town
Part: Brake pads

Watch this video to learn how to remove and replace the front brake pads on the Kymco X Town 300 scooter in simple and quick steps. After positioning the scooter on the centre stand, remove the screw from the pipe connected to the brake caliper; then unscrew the two pins of the caliper itself, detaching it from the disc, as shown in the video. At this point, remove the pads and replace them with the correct new ones; clean the caliper of any residual dirt and push the piston back to facilitate the insertion of the new pads!

Updated on 30 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the service on the Kymco X-Town 300 scooter?
How to reset the service on the Kymco X-Town 300 scooter?
X Town In this tutorial we can see how to reset the service on the Kymco X-Town 300 scooter, an extremely simple and quick operation, to be carried out only…
How to Replace the Belt on a Kymco X Town 300
How to Replace the Belt on a Kymco X Town 300
X Town In today's tutorial video, you will learn how to dismantle and replace the drive belt on the Kymco X Town 300 scooter, following the instructions bel…
How to Replace the Front Brake Pads on a Kymco X-Town
How to Replace the Front Brake Pads on a Kymco X-Town
X Town To replace the front brake pads on a Kymco X-Town, loosen the bolts securing the brake caliper located over the front disc. Once the bolts are loosen…

How to Replace the Front Headlight Bulb on the Suzuki GS 500?

In this tutorial, you will see how to replace the front headlight bulb on the Suzuki GS 500, a very simple and quick operation. Before proceeding, ensure that the key is not inserted to operate safely. Start by positioning yourself in front of the headlight in question, then locate the two screws at the bottom and unscrew them with a cross-head screwdriver. Next, separate the headlamp from the bracket, disconnect the power connector, and remove the rubber cap. At this point, simply unclip the metal clip, extract the old bulb, and fit the replacement.

Watch the video!


by ScegliAuto

More videos