Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to Removing the Rear Light of the Kymco People GT 300i

Model: Kymco People Gt 300i
Part: Tail light

Video tutorial

Today's guide will illustrate the main steps useful for removing and replacing the rear light and its bulbs on the Kymco People GT 300i scooter. First, place the central stand and begin by removing the plastic cover located above the rear light.

Then, unscrew the fixing screws of the light to remove it, disconnecting the electrical connector of the lights. At this point, remove and replace the stop bulbs if necessary, or replace the entire unit; then apply the reverse procedure for reassembling the rear light!


Updated on 28 September 2026 by ScegliAuto


Related tutorials

How to Replace the Rollers and Variator of the Kymco People GT 300i
How to Replace the Rollers and Variator of the Kymco People GT 300i
People Gt 300i Follow this guide to dismantle and replace the rollers and variator of the Kymco People GT 300i scooter. First, place your scooter on the centre stan…
How to Remove the Rear Wheel of a Kymco People GT 300i
How to Remove the Rear Wheel of a Kymco People GT 300i
People Gt 300i Today's tutorial will show you how to remove and replace the rear wheel or tyre of the Kymco People GT 300i scooter. First, place the scooter on the …
How to Change the Transmission Oil on Kymco People GT 300i
How to Change the Transmission Oil on Kymco People GT 300i
People Gt 300i This guide provides instructions on how to replace the transmission oil on the Kymco People GT 300i scooter, following these simple steps. First, pla…

How to Replace the USB Socket on the Benelli TRK 502?

To replace the USB socket on the Benelli TRK 502, loosen the screws securing the left side panel of the motorcycle, located just below the handlebars: once this panel is freed, you can remove it and locate the USB socket connector. By disconnecting this connector, you can pull the socket out of its housing: then connect the new socket to the connector, inserting it into its housing. After installation, check that the socket works by reinstalling the panel.

Watch the video!


by ScegliAuto

More videos