Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Door Panel on a Lancia Thesis

Model: Lancia Thesis MK 1 - Years 2002-2009
Part: Door trim panel

In this video, we will see step-by-step instructions for removing the front door panel on a first series Lancia Thesis. First, open the front door and start by removing the armrest, detaching it from the clips. Next, remove the various plastic covers on the panel and unscrew all the fastening screws underneath, as shown in the video. At this point, pry on the sides of the panel to unclip and remove it; finally, disconnect the handle cable and the electrical connector found at the back!

Updated on 21 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Headlamp of a Lancia Thesis
How to Remove the Front Headlamp of a Lancia Thesis
Lancia Thesis (2002-2009 / MK 1) How do you remove the front headlamp and replace the associated bulbs on a Lancia Thesis? Open the front bonnet by pulling the lever located at the b…
How to Remove the Rear Seats on a Lancia Thesis
How to Remove the Rear Seats on a Lancia Thesis
Lancia Thesis (2002-2009 / MK 1) How do you remove the rear seats from your Lancia Thesis? Here's how to do it best: enter the back of the car and lift the rear seat base (press upwa…
How to Remove the Front Headlight on the Lancia Thesis
How to Remove the Front Headlight on the Lancia Thesis
Lancia Thesis (2002-2009 / MK 1) In this short video, you will learn how to remove the front headlight from a Lancia Thesis, following the instructions below. First, open and lift th…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos