Do it yourself
Frequently asked questions about cars and motorcycles

How to Prevent Condensation in the Rear Center Bar of the Lincoln MKT

Model: Lincoln Mkt MK 1 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019

Video tutorial

The Lincoln MKT has a long bar at the back that contains the taillights, reverse lights, turn signals, and fog light. Lincoln is Ford's luxury brand and borrows many solutions from it, one of which is using a single LED in the lights.

This long bar tends to retain moisture, which can damage the internal LED; if there were more than one, the problem would be less severe, but since there is only one, if it fails, the entire light assembly goes out. To prevent moisture buildup, the YouTuber devised a simple and effective solution.

Drill a tiny hole on the side of the bar to allow air circulation and prevent condensation.


Updated on 25 May 2026 by ScegliAuto


Related tutorials

Lincoln Mkt (2010-2019 / MK 1) Replacing the key battery for your vehicle is undoubtedly one of the simplest tasks you can perform on your own without professional help. In this gu…
Lincoln Mkt (2010-2019 / MK 1) To replace the rear shock absorber on a Lincoln MKT, lift the vehicle so that the corresponding wheel is not in contact with the ground. Once the car…
Lincoln Mkt (2010-2019 / MK 1) Replacing the key fob battery in a Lincoln MKT, as shown in this tutorial, is a very simple task. You won't need any special tools, just a replacemen…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Resetting the Service Light on the Mitsubishi Canter

When it is necessary to change the engine oil of the Mitsubishi Canter, a warning on the dashboard alerts us to this requirement. Once this maintenance task is completed, you must reset the control system. Sit in the driver's seat and turn on the instrument panel. Without starting the engine, press and hold the accelerator pedal for twenty seconds. After this time interval, while still holding the accelerator pedal, pump the brake pedal six times. Once done, the warning on the instrument panel will turn off, confirming the reset.

Watch the video!


by ScegliAuto

More videos