Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Adjust the Valves of the LML Star 125

Model: Lml Star 125
Part: Checks and maintenance

Video tutorial

This guide will show you how to adjust the valve clearance of the LML Star 125 four-stroke. First, place it on the centre stand and begin by removing the side panel of the engine; then remove the spark plug and the valve cover by unscrewing the screws, as shown in the video.

At this point, use a feeler gauge to set the correct clearance, which is approximately 0.6 mm, as indicated in the user and maintenance manual; once the adjustment is made, refit the small valve cover by reversing the procedure.


Updated on 22 October 2026 by ScegliAuto


Related tutorials

How to Remove the Front Wheel of an LML Star 125
How to Remove the Front Wheel of an LML Star 125
Star 125 Before starting, lift your LML Star 125. Begin by turning the wheel fully to the right, allowing easy access to all the fixing bolts. Then, unscrew a…
How to Replace the Fuel Tank on an LML Star 125
How to Replace the Fuel Tank on an LML Star 125
Star 125 Today's instructions will show you how to remove and replace the fuel tank on the LML Star 125, as well as the Piaggio Vespa PX 125. First, place the…
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
How to Replace the Exhaust on the Piaggio Vespa PX 125 - LML Star 125
Star 125 Below are the steps necessary to remove and replace the exhaust on the Piaggio Vespa PX 125 and the LML Star 125. First, place the central stand and …

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos