Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Voltage Regulator on LML Star 125

Model: Lml Star 125

Video tutorial

In this video, follow the steps to remove and replace the voltage regulator on an LML Star 125cc, as well as on the 150 and 200 models. First, open the seat and release the levers to remove the left storage box; then unscrew the bolts of the spare wheel to remove it, as shown in the video.

Next, unscrew the battery terminal bolts and remove the battery; take off the battery bracket and move the ignition coil away; unscrew the bolts of the voltage regulator and disconnect all the electrical cables, replacing it with the new one!


Updated on 17 April 2026 by ScegliAuto


Related tutorials

How to Remove the Front Wheel of an LML Star 125
How to Remove the Front Wheel of an LML Star 125
Star 125 Before starting, lift your LML Star 125. Begin by turning the wheel fully to the right, allowing easy access to all the fixing bolts. Then, unscrew a…
How to Replace the Starter Motor on the LML Star 125
How to Replace the Starter Motor on the LML Star 125
Star 125 Today's guide will illustrate the main steps to dismantle and replace the starter motor on the LML Star 125, as well as the Piaggio Vespa PX 125. Fir…
How to Replace the Fuel Tank on an LML Star 125
How to Replace the Fuel Tank on an LML Star 125
Star 125 Today's instructions will show you how to remove and replace the fuel tank on the LML Star 125, as well as the Piaggio Vespa PX 125. First, place the…

How to Reset the Service Light on the Gilera Nexus 500

This video shows the procedure to reset the service light on the Gilera Nexus when the light remains on after a service. The procedure is straightforward and takes less than a minute. To reset the light, press the mode button and the odo/set button simultaneously. While holding them down, turn the ignition key to the ON position. Once the instruments are on, release the buttons and press the mode button once. The maintenance light will illuminate; hold the mode button for a few seconds to reset it.

Watch the video!


by ScegliAuto

More videos