Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the wheel with the spare on the LML Star 200

Model: Lml Star 200
Part: Wheel

Video tutorial

Today, we will see the instructions that will allow you to remove and replace the wheel with the spare on the LML Star 200, as well as on the Piaggio Vespa PX 200. First, put the central stand down and start removing the left side panel of the wheel by rotating the levers located above the fuel tank; then, unscrew the bolts of the spare wheel to remove it, as shown in the video.

At this point, lift the rear wheel off the ground and unscrew the bolts to remove it and replace it with the spare, securing the bolts in a criss-cross pattern, and reposition the old wheel in the side compartment!


Updated on 7 October 2026 by ScegliAuto


Related tutorials

How do you replace the rear brake drum of the LML Star 200?
How do you replace the rear brake drum of the LML Star 200?
Star 200 In order to replace the rear brake drum of the LML Star 200, you will need to loosen the central nut that secures the rear wheel axle of the motorcyc…
How to Replace the Fuel Pump on an LML Star 200?
How to Replace the Fuel Pump on an LML Star 200?
Star 200 To replace the fuel pump on an LML Star 200, loosen the screws securing the right side cover panel of the bike, located near the rear wheel: once thi…
How do you replace the clutch of the LML Star 200?
How do you replace the clutch of the LML Star 200?
Star 200 To replace the clutch of the LML Star 200, you need to remove the side panel located on the right side of the rear wheel. Once this panel has been re…

How to Change the Transmission Oil in the Honda SH 150i Scooter?

Changing the transmission oil in the Honda SH 150i scooter, as shown in this tutorial, is an extremely simple and quick operation. First, wait until the engine is cool enough, then locate the three bolts at the rear of the casing and position a container underneath them. Next, use a 12mm socket to remove the two inner bolts, allowing all the oil in the system to drain out, and then tighten the lower bolt. At this point, simply pour in the new oil through the upper hole, using a syringe and a thin tube if necessary.

Watch the video!


by ScegliAuto

More videos