Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today's instructions will allow you to carry out the routine maintenance service by changing the engine oil and oil filter on the Malaguti Madison 150 scooter. First, place the scooter on the centre stand and start unscrewing the oil drain bolt located under the engine, letting it drain into a container for about ten minutes; remove and replace the oil filter cartridge as shown in the video. At this point, replace the air filter and then top up with new engine oil (with the appropriate specifications).

Posted on 22 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the engine oil of the Malaguti Madison 150?
How do you replace the engine oil of the Malaguti Madison 150?
Madison 150 To replace the engine oil of the Malaguti Madison 150, you need to loosen the drain plug located in the central lower part of the vehicle: once this …
How to Replace the Variator on the Malaguti Madison 150?
How to Replace the Variator on the Malaguti Madison 150?
Madison 150 To replace the variator on the Malaguti Madison 150, you will need to loosen the screws that secure the transmission cover: this is located on the ri…
How to Remove the Engine and Cylinder Head of the Malaguti Madison 150
How to Remove the Engine and Cylinder Head of the Malaguti Madison 150
Madison 150 Follow this guide for instructions on removing the engine block from the chassis and the cylinder head of the Malaguti Madison 150 scooter. First, pl…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos