Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Engine and Cylinder Head of the Malaguti Madison 150

Model: Malaguti Madison 150
Part: Engine

Video tutorial

Follow this guide for instructions on removing the engine block from the chassis and the cylinder head of the Malaguti Madison 150 scooter. First, place your scooter on the centre stand and start disconnecting the rear suspension and the engine's central pin, which is fixed to the frame; disconnect the various wiring to lower the engine, as shown in the video.

At this point, remove the cylinder head by taking out the spark plug and unscrewing the bolts; then slide out the cylinder and subsequently remove the piston by taking out the pin. Finally, reassemble everything!


Updated on 27 June 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil and Oil Filter on a Malaguti Madison 150
How to Change the Engine Oil and Oil Filter on a Malaguti Madison 150
Madison 150 Today's instructions will allow you to carry out the routine maintenance service by changing the engine oil and oil filter on the Malaguti Madison 15…
How to Replace the Variator on the Malaguti Madison 150?
How to Replace the Variator on the Malaguti Madison 150?
Madison 150 To replace the variator on the Malaguti Madison 150, you will need to loosen the screws that secure the transmission cover: this is located on the ri…
How to Replace the Variator on the Malaguti Madison 150
How to Replace the Variator on the Malaguti Madison 150
Madison 150 To replace the variator on the Malaguti Madison 150, loosen the screws securing the cover of the casing located near the rear wheel. Once the cover i…

How to Replace the Water Pump on the Gilera Runner VXR 200?

To replace the water pump on the Gilera Runner VXR 200, loosen the screws that secure the transmission cover on the left side of the scooter, near the rear wheel. Once this cover is removed, you will find the water pump directly above the variator. You will need to loosen the screws that secure both the pump and the variator to their housing, allowing you to insert the new components. After installation, close everything with the cover and check its operation.

Watch the video!


by ScegliAuto

More videos