Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Malaguti
    3. : Centro 125
This maintenance should be performed when, turning the ignition key of the scooter, it shows no signs of life. The ECU, for those who don't know, is located under the floor connected to a single connector. Instead of replacing the entire ECU (which costs a lot of money), use a milling tool to make a small opening at the bottom of the ECU at the suggested dimensions in the video. This will free the damaged voltage regulator. Remove it and replace it with another 5-volt regulator. Seal the opening you created with hot glue and refit the ECU.

Updated on 2 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Piston of the Malaguti Centro 125?
How to Replace the Piston of the Malaguti Centro 125?
Centro 125 To replace the piston of the Malaguti Centro 125, open the under-seat compartment by unscrewing the screws inside and completely removing the interna…

How to Replace the Engine Oil and Oil Filter on an Aprilia RSV 1000

This short video will show you how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia RSV 1000 motorcycle. First, place your motorcycle on the centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then use the appropriate tool to unscrew and remove the oil filter, replacing the cartridge with a new one as shown in the video. Finally, unscrew the filler screw and top up by pouring in the suitable oil for your engine!

Watch the video!


by ScegliAuto

More videos