|
Do it yourself
| |||
| ||||
|
Model: Malaguti Dune 125
To replace the grips on a Malaguti Dune 125, grasp the old grips and pull them back to remove them from their housing. Once the old grips are removed, clean the end of the handlebar to make it smooth; at this point, you can insert the new replacement grips and push them fully until they contact the buttons located under the levers. After installing the new grips, start the bike to check that everything is functioning.
Updated on 26 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Dune 125
You can replace the grips of the Malaguti Dune 125 by loosening the screws that secure the controls of the handlebars on the inside of the grips them…
Dune 125
To install handguards on a Malaguti Dune 125, first unscrew the protective caps located at the ends of the grips. Once removed, loosen the screws tha…
Dune 125
The spark plug of the Malaguti Dune 125 can be replaced by disconnecting the corresponding ignition coil located on the top of the engine cylinder: o…
|
How to Top Up the Oil in the Aprilia SR 50 R Scooter?
In this tutorial, you will see how to top up the oil in the Aprilia SR 50 R scooter, a very simple and quick operation to perform periodically. First, open the small lower compartment and retrieve the supplied tools, then remove the screws securing the front panel located at the back. Once removed, locate the oil reservoir, which is on your left, and unscrew the cap. At this point, proceed to top up the oil until you reach the optimal level, then reassemble everything by following the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
