Do it yourself
Frequently asked questions about cars and motorcycles
You can bleed the brakes on the Malaguti Dune 125 by loosening the small bleed screw located at the brake caliper for both the front and rear brakes; this will allow the old fluid inside the braking system to escape. To remove the last residues, pump the brake lever a few times; once the fluid has completely drained, you can close the bleed screw and top up from the reservoirs located on the handlebars, right next to the side levers.

Posted on 22 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Dune 125 To bleed the braking system of the Malaguti Dune 125, remove the bolt located on the brake caliper to open the appropriate cap. Connect a tube to thi…
Dune 125 In this video, you will find the main instructions for performing an engine oil change during the regular maintenance service on a Malaguti Dune 125,…
Dune 125 You can replace the valves on a Malaguti Dune 125 by loosening the screws that secure the seat from its housing, allowing you to detach it and access…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos