Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Additional Control Unit on the Malaguti Spectre 125

Model: Malaguti Spectre 125
Part: Control unit

This video is currently unavailable

Let's briefly go through the instructions to install the module of the additional control unit for adjusting parameters on the Malaguti Spectre 125 motorcycle; remember that these kits are to be used exclusively on the track. To install the new control unit, simply disconnect the old one and connect the new one; on the left side of the motorcycle, disconnect the electrical connectors of the control unit, then add the new module.

Securely fasten the control unit to the motorcycle frame using screws or ties, following the video tutorial until the end!


Updated on 2 August 2026 by ScegliAuto


Related tutorials

How to Replace and Install the Engine Control Unit on Malaguti Spectre 125
How to Replace and Install the Engine Control Unit on Malaguti Spectre 125
Spectre 125 Today's steps will show you how to replace or install the engine control unit on the Malaguti Spectre 125, following the instructions below. First, p…
How do you replace the exhaust pipe of the Malaguti Spectre 125?
How do you replace the exhaust pipe of the Malaguti Spectre 125?
Spectre 125 The replacement of the exhaust installed on the Malaguti Spectre 125 can be carried out by loosening the screws that fix the exhaust terminal to its …
How to Replace the Exhaust on the Malaguti Spectre 125?
Spectre 125 To replace the exhaust on the Malaguti Spectre 125, loosen the screws securing the exhaust tip to its housing on the right side of the vehicle near t…

Replacing the Rear Brake Pads of the BMW G310 GS

Follow these brief instructions to remove and replace the rear brake pads (this also applies to the front ones) of the BMW G310 GS motorcycle. First, place the bike on a stand and start by removing the pin and the clip from the rear brake caliper; then remove the old brake pads as shown in the video. Next, clean the caliper of any residual dirt, install the new original brake pads, and secure the pin and clip to lock everything in place, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos