Do it yourself
| ||||
|
Model: Malaguti Spectre 125
Today's steps will show us how to replace or install the engine control unit of the Malaguti Spectre 125, following the instructions below. First, we put the side stand and start by removing the plastic partition found on the left side, unscrewing the screw; we will find the control unit at the back, which we will disconnect to remove, as shown in the video. At this point, if necessary, we replace the control unit and install the new one, making the electrical connection; then we start the engine and check its correct operation.
Posted on 20 May 2024 by ScegliAuto
How to install the additional control unit on the Malaguti Spectre 125.
Spectre 125 Let's briefly go over the instructions that will allow us to install the additional control unit module for regulating parameters on the Malaguti Spe |
Change the Yamaha Tracer 900 engine oil and oil filterWe see below the step-by-step instructions to be able to carry out the routine maintenance service, replacing the engine oil and the oil filter, of the Yamaha Tracer 900. First of all we put our bike on the central stand and begin to unscrew the vent bolt of the the oil that we find under the engine, letting it drain in a container for about ten minutes; after which we use the special key to unscrew and remove the filter cartridge, replacing it with the new one, as shown in the video. Finally, unscrew the filler cap and top up with the new oil! by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.277
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |