Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Perform Routine Maintenance on the Malaguti Phantom F12

Model: Malaguti Phantom F12 50
Part: Checks and maintenance

Video tutorial

The instructions in this video will show you how to carry out the routine maintenance service on the Malaguti Phantom F12 50 scooter. First, place the scooter on its centre stand and start by unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then check the condition of the brakes and replace them if necessary, as shown in the video.

At this point, unscrew the screws of the transmission cover to check the condition of the belt, replacing it if necessary!


Updated on 22 September 2026 by ScegliAuto


Related tutorials

How to Remove the Instrument Cluster from a Malaguti Phantom F12
How to Remove the Instrument Cluster from a Malaguti Phantom F12
Phantom F12 50 Before starting, position your Malaguti Phantom F12 on the central stand. Begin by unscrewing and removing the lower screws that secure the instrumen…
How to Remove the Variator Cover of a Malaguti Phantom F12?
How to Remove the Variator Cover of a Malaguti Phantom F12?
Phantom F12 50 Good morning, today’s objective is to open the variator cover of our Malaguti Phantom F12. Start by placing the scooter on the centre stand. Next, re…
How to Dismantle and Clean the Transmission of the Malaguti Phantom F12 50
How to Dismantle and Clean the Transmission of the Malaguti Phantom F12 50
Phantom F12 50 Today's instructions will show you the procedure for dismantling and cleaning the transmission of the Malaguti Phantom F12 50 scooter. First, remove …

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos