Do it yourself
Frequently asked questions about cars and motorcycles

Replacement of the rear brake pads and discs of the Mercedes CLA.

Model: Mercedes CLA C117, X117 - Years: 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Brake pads

See other generations:
Video tutorial

In this guide we will see the step-by-step instructions that will allow us to disassemble and replace the rear brake pads and discs of the Mercedes CLA. First, we lift the car and start by removing the rear wheel; then we unscrew the screws securing the brake caliper, removing it from the disc, as shown in the video.

At this point, we unlock the caliper piston to remove the pads, proceeding with the replacement of the brake disc if necessary; we clean the caliper from any residual dirt and then reassemble the pads, following the same procedure on the other side.


Posted on 10 February 2025 by ScegliAuto


Related tutorials

Mercedes CLA (2013-2019 / C117, X117) If the brake light bulb on your 2014 Mercedes CLA 250 is malfunctioning and you want to learn how to replace it yourself, follow this step-by-step gu…
Mercedes CLA (2019-2025 / X118, C118) To gain access to the OBD port of your Mercedes CLA 250 and connect a diagnostic tool, you need to carefully read the following guide and apply it st…
Mercedes CLA (2019-2025 / X118, C118) In this new guide for your Mercedes CLA C118, discover how to replace the battery inside the key. First, locate the metal part on the top and pull it…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Remove the Cabin Fan in the Nissan Qashqai?

The cabin fan in any vehicle, specifically the Nissan Qashqai this time, may fail for various reasons: blown fuse, shorted wire, but the most serious issue is a broken fan. This means you need to remove it and check it, and if necessary, replace it. In this vehicle, it is located in the footwell area, so you will need to remove the carpet covering of the centre tunnel, then carefully navigate through the various wires present, and finally, once located, disconnect the electrical wires supplying it and unscrew the fixing screws.

Watch the video!


by ScegliAuto

More videos