|
Do it yourself
| |||
| ||||
How to Replace the Fuel Pump on a Mercedes C-Class
Model: Mercedes Classe C
- Years 2007-2013
To replace the fuel pump on a Mercedes C300 W204, the fuel level must be below half (preferably a quarter tank). The tank is of the "saddle" type: the main pump is on the passenger side, while a transfer pump moves fuel from the other side. The pump has one main electrical connector (plus another attached above, not part of the pump). The fastening is a metal ring (about 7 in in diameter) that is very difficult to unscrew: a specific tool is needed, otherwise, you risk damaging the plastic tank. Once the ring is removed, the pump comes out (a spring pushes it). Disconnect the connectors and hoses (one for transfer). The new pump should be inserted with the float facing the front of the car, with the two springs at the back. Reconnect the hose and the connector. Replace the ring and close the cover with four 8 mm bolts. The new pump (found on eBay with code 366660305639 for $64.25 with free shipping) should provide more pressure and prevent boiling.
Posted on 25 September 2026 by ScegliAuto
Video tutorial
Related tutorials
Mercedes Classe C
(2007-2013 /
W204)
.. and replace the fuel pump on the Mercedes C-Class. First, open the rear doors and start by removing the rear seat by lifting it up; then remove the.. …
Mercedes Classe C
(2000-2007 /
W203)
.. and replace the fuel pump on the Mercedes C-Class, following the instructions below. First, remove the rear seat of your car, then take off the fuel.. …
Mercedes Classe C
(1993-2000 /
W202)
.. fuel pump and its filter on a Mercedes-Benz C-Class. First, lift the rear of the vehicle slightly and begin by removing the fuel filter, disconnecting.. …
Other guides you may be interested in
|
How to Connect the Cables to the Battery of the Citroen Xsara Picasso?
In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.069
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |