Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Sl
    4. : Removing the front bumper on Mercedes Sl

Mercedes Sl - Video tutorial

Model: Mercedes Sl R231, MK 7 - Years 2011-2021
Part: Front bumper
Operation: Removing the front bumper on Mercedes Sl

Raise the hood and put on the appropriate support rod. Using a torx t25 wrench, unscrew the first four upper lateral screws (two on each side). Now, with an 8 mm socket, unscrew the two screws on each side present in the area behind the lights, as shown in the video. Then unscrew the bolts that secure the wheel arches, so as to be able to move them and find the screws that secure the bumper below in this area. Lift the car with a jack and unscrew all the 8 mm screws under the front bumper, as well as remove the fixing clips. Finally, unscrew the two screws on the sides of the plate and you can remove the bumper.


Posted on 14 January 2024 by ScegliAuto



Mercedes SL R230 rear bumper removal instructions
Mercedes Sl (2001-2011 / R230) In this video tutorial we will see how to remove and replace the rear bumper of a Mercedes SL R230. First we go to remove the screws that we find on
How to remove the door panel of the Mercedes SL
Mercedes Sl (2011-2021 / R231, MK 7) We see in this video the instructions that will allow us to remove the front door panel of the Mercedes SL, in simple steps. First of all we open the
Mercedes SL front seat disassembly guide
Mercedes Sl (1989-2001 / MK 5, R129) In this video tutorial we will see the main instructions that will allow us to disassemble the front seat of the Mercedes SL, following the instructi

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos