Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. CLA
    4. : How to check and top up the engine oil in the Mercedes CLA?

Mercedes CLA - Video tutorial

Model: Mercedes CLA X117, C117 - Years 2013-2019
Part: Engine oil
Operation: How to check and top up the engine oil in the Mercedes CLA?

In this tutorial we can see how to check and top up the engine oil in the Mercedes CLA, a very simple and quick operation. First of all, we wait for the engine to be cold enough, then we open the hood and locate the dipstick located on the right rear side of the engine, recognizable by the presence of a yellow ring. We then extract it, clean it with an absorbent cloth, reinsert it and extract it again. If the level is below the control section, we will have to open the large indicated cap and add the necessary amount of oil to reach the ideal level.


Posted on 19 May 2024 by ScegliAuto



How to top up the radiator reservoir on Mercedes Cla
Mercedes CLA (2013-2019 / X117, C117) How to do maintenance on our car? Let's see how to top up the radiator coolant reservoir on Mercedes Cla. We pull the plastic lever to unlock the fro
Guide to replacing the battery of the Mercedes CLA
Mercedes CLA (2013-2019 / X117, C117) Let's briefly see in this guide the steps that will allow us to disassemble and replace the battery of the Mercedes CLA. First, we open the hood and
Where are the fuses for the headlights in the Mercedes CLA?
Mercedes CLA (2013-2019 / X117, C117) If the headlights of our Mercedes CLA have suddenly stopped working, and the respective bulbs are in good condition, we can then check the state of t

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos