Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the oil filter and motor oil of the MG ZS

Model: MG ZS Zs11 - Years 2017-2024
Part: Engine oil

To perform the oil change and oil filter replacement on an MG ZS car, it is necessary to lift the vehicle on a jack or use suspension stands. After lifting the vehicle, it is necessary to place a container under the oil pan and, using a torque wrench, unscrew the drain plug. As the oil drains out, using a 20mm wrench, unscrew the oil filter next to the pan. Insert the new filter, close the box, screw the nut of the pan, and lower the vehicle. Pour 4 liters of oil into the oil tank.

Posted on 24 September 2025 by ScegliAuto

Video tutorial

Related tutorials

How to change engine oil on Mg Zs
How to change engine oil on Mg Zs
MG ZS (2017-2024 / Zs11) Let's see in this guide the instructions that will allow us to replace the engine oil and the oil filter, carrying out the ordinary maintenance coupo…
How to change the engine oil on the Mg Hs
How to change the engine oil on the Mg Hs
MG ZS (2017-2024 / Zs11) Do we want to proceed with replacing the engine oil and oil filter on our car? In the description below, we find all the useful steps and necessary i…
How to replace the cabin air filter of the MG ZS
How to replace the cabin air filter of the MG ZS
MG ZS (2017-2024 / Zs11) When the air quality inside the cabin of your MG ZS worsens, it means it's time to replace the air filter. In the following guide, we will explain ho…

Other guides you may be interested in

How to Replace the Front Headlamp Bulb on a Fiat Grande Punto

To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder.

Watch the video!


by ScegliAuto

More videos