Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Centre Tunnel on a Mini Cooper

Model: Mini Mini F56, F57, F54, F55 - Years 2014-2023
Part: Center console tunnel

Today, in this short and simple guide, learn how to remove and replace the centre tunnel on a Mini Cooper. First, get inside the vehicle and start by removing the two plastic covers located at the bottom on both the driver and passenger sides; then remove the gear gaiter and take out the switch panel and controls, disconnecting the electrical connector found underneath, as shown in the video. At this point, remove the handbrake cover and subsequently the entire centre tunnel, applying the reverse procedure for reassembly!

Updated on 2 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Headlamp from a Mini Cooper
Mini (2007-2014 / R56, R55, R57) Before starting, open the front bonnet of your Mini Cooper. Begin by unscrewing and removing the bolts that secure the front headlamp to the vehicle.…
How to Install an Armrest in the Mini Cooper?
How to Install an Armrest in the Mini Cooper?
Mini (2007-2014 / R56, R55, R57) In this tutorial, see how to install an armrest in the Mini Cooper, a very simple operation. First, remove the rear storage compartment, then take ou…
How to Replace the Timing Belt on the Mini Cooper
How to Replace the Timing Belt on the Mini Cooper
Mini (2007-2014 / R56, R55, R57) Replacing the timing belt on the Mini Cooper model R56 is a bit complex to perform independently. Start by opening the front bonnet and removing the …

How to Reset the Central Locking of the Volkswagen Golf 4?

If the central locking system of the Volkswagen Golf 4 is not working, it is likely necessary to reset the system: to do this, open the driver's door and detach the side panel of the dashboard next to the steering wheel. Under this panel, you will find the fuses, including the one for the central locking, which is indicated in the manual as number 14. To reset the system, remove this fuse from its housing, then reinsert it or replace it with a new one of the same amperage: this will reset the central locking system.

Watch the video!


by ScegliAuto

More videos