Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Spark Plugs of the Moto Guzzi V7

Model: Moto Guzzi V7 Iii
Part: Spark plugs

Video tutorial

The instructions in this guide will show you how to remove and replace the spark plugs of the Moto Guzzi V7 engine. First, place the motorcycle on the centre stand and begin removing the spark plug connectors found on the cylinder heads; then use a socket wrench with an extension to unscrew and remove them, as shown in the video.

Next, install the new spark plugs of the correct type and with the same thread pitch; hand-tighten them before gently tightening with a spanner, reconnect the spark plug cables, and finally start the engine!


Updated on 11 October 2026 by ScegliAuto


Related tutorials

How to Perform a Full Service on the Moto Guzzi V7 III
How to Perform a Full Service on the Moto Guzzi V7 III
V7 Iii In this video tutorial, follow the steps to carry out a full service for routine maintenance, including an oil change and filter replacements, on the…
How to replace the rear brake pads on the Moto Guzzi V7 III?
How to replace the rear brake pads on the Moto Guzzi V7 III?
V7 Iii To replace the rear brake pads on the Moto Guzzi V7 III, loosen the bolts securing the brake caliper to the corresponding wheel disc. Once these bolt…
How do you replace the air filter of the Moto Guzzi V7 III?
How do you replace the air filter of the Moto Guzzi V7 III?
V7 Iii In order to replace the air filter of the Moto Guzzi V7 III, you need to insert the key into the lock located under the seat, on the left side of the…

How to Replace the Headlight Bulb on the Suzuki Address 110

To replace the headlight bulb on the Suzuki Address 110, you must completely remove the wing mirrors so that you can rotate them counterclockwise: once removed, proceed to loosen the screws securing the front fairing, located at the sides of the instrument cluster. Once the front fairing is removed, disconnect the internal connector of the headlight, allowing the bulb inside to be extracted and replaced with a new one; after replacement, reassemble all the removed parts.

Watch the video!


by ScegliAuto

More videos