Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change a Wheel Bearing on a Morini GranPasso

Model: Moto Morini Granpasso
Part: Bearing

Video tutorial

On this MotoMorini GranPasso, the rear wheel wobbles a lot. Considering it is a bike that goes very fast, this is a dangerous defect. Here’s how the bearing was changed.

Removing the rear wheel is very easy; it is held by a single bolt. In fact, the bearing was destroyed.

Remove the spacer between the two bearings, and note that there are also bearings in the sprocket holder. Take the opportunity to change those as well.

The damaged one had left some filings, which need to be blown out. To reinsert them, use a plastic hammer to tap on the outer edge - never on the inner edge - although the best method would be to use a press.


Updated on 16 July 2026 by ScegliAuto


Related tutorials

How to Replace the Belt on the Moto Morini 350
How to Replace the Belt on the Moto Morini 350
Morini 350 In this video, we will discover the instructions that will allow you to remove and replace the drive belt on the Moto Morini 350. First, remove the s…
How to Replace the Timing Belt on a Moto Morini 400
How to Replace the Timing Belt on a Moto Morini 400
Morini 400 In this video tutorial, you will learn how to remove and replace the timing belt on a Moto Morini 400, following the instructions below. First, place…
Removing the Valve on Moto Morini Strada
Removing the Valve on Moto Morini Strada
Fiat Strada Today, you will see how to remove one of the valves from a 1978 Moto Morini Strada. First, remove the head screws: then access the valve compartment …

How to Replace the Headlight Bulb of a Triumph Speed Twin?

To replace the headlight bulb of the Triumph Speed Twin, you need to loosen the screws that secure the headlight unit in place: these screws will be located at the bottom right and bottom left of the headlight unit. Once these are loosened, you can proceed to pull the headlight from its housing and disconnect the connectors inside: the corresponding bulb can now be extracted from inside the headlight unit, allowing you to insert the new one, remounting all the parts you just removed.

Watch the video!


by ScegliAuto

More videos