Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Before you start, position your MV Augusta Brutale upright using a motorcycle stand. To effectively drain the used engine oil, run the engine for a few minutes. Next, place a container underneath the oil sump. Then, unscrew and remove the lower oil drain plug. This will allow all the engine oil to flow out. Once done, refit the lower plug, then unscrew and remove the upper filler plug. At this point, use a funnel to add new engine oil, and then refit the filler plug to complete the replacement.

Updated on 14 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Reset the Trip Meter on an MV Augusta Brutale 800
How to Reset the Trip Meter on an MV Augusta Brutale 800
Brutale 800 Before you begin, sit on the seat of your MV Augusta Brutale 800 and lift the side stand. Start by turning the ignition key to switch on the instrume…
How to Change the Engine Oil and Oil Filter on a MV Agusta Brutale 800 RR
How to Change the Engine Oil and Oil Filter on a MV Agusta Brutale 800 RR
Brutale 800 Today, let's explore the step-by-step instructions that will allow you to perform the routine maintenance service by changing the engine oil and oil …
How to Change the Engine Oil of the MV Agusta Brutale 800?
How to Change the Engine Oil of the MV Agusta Brutale 800?
Brutale 800 To change the engine oil of the MV Agusta Brutale 800, loosen the drain plug located at the bottom centre of the vehicle's oil sump. Once the plug is…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos