Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the engine oil of the MV Agusta Brutale 800, loosen the drain plug located at the bottom centre of the vehicle's oil sump. Once the plug is loosened, allow all the used oil to drain into a suitably positioned container. After the oil has completely drained, remove the oil filter located in the same position and replace it with a new one. After replacing the filter, top up the oil by adding the necessary amount through the filler cap on the left side of the motorcycle.

Updated on 9 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the motor oil of the MV Agusta Brutale 800?
How do you replace the motor oil of the MV Agusta Brutale 800?
Brutale 800 The motor oil in the MV Agusta Brutale 800 system can be replaced by loosening the drain plug of the oil pan, located in the lower central part of th…
How to Change the Engine Oil and Oil Filter on a MV Agusta Brutale 800 RR
How to Change the Engine Oil and Oil Filter on a MV Agusta Brutale 800 RR
Brutale 800 Today, let's explore the step-by-step instructions that will allow you to perform the routine maintenance service by changing the engine oil and oil …
How do you replace the engine oil of the MV Agusta Brutale 800?
How do you replace the engine oil of the MV Agusta Brutale 800?
Brutale 800 The engine oil of the MV Agusta Brutale 800 can be replaced by loosening the drain plug of the oil pan, which is located in the central lower part of…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos