Do it yourself
Frequently asked questions about cars and motorcycles

Model: Mvagusta Dragster 800
Part:

In this video tutorial, you will learn how to remove the original number plate holder and replace it with a new one (of a different model) on the MV Agusta Dragster 800. First, position your bike on a stand and start unscrewing the fixing screws of the original number plate holder, located at the bottom near the sprocket; use an Allen key for this, removing the brackets and disconnecting the electrical connectors of the lights. Once the original number plate holder is removed, you can proceed with the installation of the new one, according to the model and its features; follow the video until the end!

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Dragster 800 It will be possible to replace the exhaust of the MV Agusta Dragster 800 RC by loosening the screws that secure the exhaust terminal to its housing o…
Dragster 800 To replace the exhaust on the MV Agusta Dragster 800, loosen the screws securing the piece at the rear, near the rear mudguard. Once the screw fixing…
Dragster 800 Today, discover the procedure to replace the coolant in the Mv Agusta Dragster 800 motorcycle, as well as the Brutale. First, place your motorcycle o…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos