Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the third brake light bulbs on the Opel Corsa

Model: Vauxhall Corsa Corsa D - Years 2006-2014
Part:

In this guide we will see the instructions that will allow us to disassemble and replace the third brake light bulbs of the Opel Corsa. First of all, let's move to the back and open the trunk door; then unscrew the two internal screws of the rear door, behind the third brake light, disconnecting the electrical connector of the bulbs to remove it, as shown in the video. At this point, replace any faulty bulbs with new ones, of the correct type and with the same attachment; finally, reassemble and connect the third brake light, verifying the operation of the lights.

Posted on 28 September 2025 by ScegliAuto

Video tutorial

Related tutorials

Replacement of the third brake light on the Opel Corsa
Replacement of the third brake light on the Opel Corsa
Vauxhall Corsa (2006-2014 / Corsa D) In these short and simple steps, we will see the process of disassembly and replacement of the third brake light bulbs of the Opel Corsa. First, we o…
How to replace the third brake light on the Opel Corsa D
How to replace the third brake light on the Opel Corsa D
Vauxhall Corsa (2006-2014 / Corsa D) In this new guide dedicated to all of you who own an Opel Corsa D, we will discover the steps you need to follow if you want to replace the third bra…
Instructions for Removing the Third Brake Light
Instructions for Removing the Third Brake Light
Vauxhall Corsa (2000-2006 / Corsa C) The third brake light is located at the top edge of the rear tailgate, just above the heated rear window; it is secured with clips. To remove it, pul…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos