|
Do it yourself
| |||
| ||||
How to Remove the Exterior Mirror of the Opel Meriva B
Model: Vauxhall Meriva
MK 2, Meriva B
- Years 2010-2017
The exterior rear-view mirror of the second generation Opel Meriva, known as B and available on the market since 2010, is mounted directly on the door panel rather than on the A-pillar, as is usually the case. To remove it, you do not need to take off the inner door trim panel; instead, you must remove the mirror cap to access the central mounting pin located at the base of the support. Proceed in reverse for its subsequent installation.
Updated on 26 February 2026 by ScegliAuto
Video tutorial
Related tutorials
Vauxhall Meriva
(2010-2017 /
MK 2, Meriva B)
Below we will see the instructions useful for disassembling and replacing the external rearview mirror of the Opel Meriva. First, we open the front d…
Vauxhall Meriva
(2010-2017 /
MK 2, Meriva B)
Today's guide will show us the main steps that will allow us to disassemble and replace the external rearview mirror of the Opel Meriva. First, we op…
Vauxhall Meriva
(2010-2017 /
MK 2, Meriva B)
In today's video we will see the instructions that will allow us to disassemble the exterior mirror of an Opel Meriva B, second series. First of all …
Other guides you may be interested in
|
How to Replace the Front Headlamp Bulb on a Fiat Grande Punto
To replace the front headlamp bulb on a Fiat Grande Punto, first open the bonnet. Once done, access the rear of the headlamp where the bulb needs replacing (the bulb is of type H4). Locate the rubber cover that protects the electrical contacts and bulbs from water and moisture. Remove it by pulling on the tab. Now, pull the connector for the bulb's power supply and disconnect it from its position. At this point, push down on the top of the spring that holds the bulb in place, and you can extract the bulb from its housing. To fit the new bulb, follow the steps in reverse as shown in the images. The video also shows how to remove the position bulb, which is located just below the H4. After disconnecting the power supply, you can extract it along with the bulb holder by pressing the two tabs to release it and pulling. The bulb can then be removed from its position in the bulb holder. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.087
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
