|
Do it yourself
| |||
| ||||
|
Model: Peugeot Speedfight
To replace the ignition switch on a Peugeot Speedfight, loosen the screws securing the plastic panel of the front shield located directly under the handlebars. Once these screws are loosened, you can detach the panel to access the screws holding the ignition switch. When these screws are also loosened and the connected wires have been removed, you can completely replace the switch with a new one; finally, remount the previously removed panel.
Updated on 7 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Speedfight
To replace the shock absorbers of the Peugeot Speedfight, loosen the bolts that secure them at the top and bottom, both for the front and rear wheels…
Speedfight
In today's tutorial video, you will see the steps that will allow you to remove the variator from a Peugeot Speedfight scooter. First, position your …
Speedfight
In this guide, see how to remove and replace the front wheel or tyre of the Peugeot Speedfight scooter by following these simple steps. First, place …
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
