Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the headlamp bulb on the Peugeot Tweet 125, loosen the screws securing the front fairing, located at the sides of the instrument panel. Once these screws are loosened, you can unscrew the mirrors by rotating them, allowing them to be completely detached. After removing the mirrors, you can fully detach the front fairing to disconnect the internal connectors of the headlamp and remove the internal bulb. At this point, connect the new bulb, reposition the front fairing and the headlamp.

Updated on 3 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the front headlight bulb in the Peugeot Tweet 125 scooter?
How to replace the front headlight bulb in the Peugeot Tweet 125 scooter?
Tweet 125 In this tutorial, we can see how to replace the headlight bulb in the Peugeot Tweet 125 scooter, an extremely simple and quick operation. First of al…
How to replace the front wheel bearing on the Peugeot Tweet 125?
How to replace the front wheel bearing on the Peugeot Tweet 125?
Tweet 125 To replace the front wheel bearing on the Peugeot Tweet 125, you need to loosen the screws that secure the front wheel to the corresponding fork: onc…
How to replace the battery of the Peugeot Tweet 125
How to replace the battery of the Peugeot Tweet 125
Tweet 125 Today's instructions will show us how to disassemble and replace the battery of the Peugeot Tweet 125 scooter, as well as the Tweet 50. First, we put…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos