Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the ignition switch of the Piaggio Vespa PX 125, you need to remove the panel located on the front internal part of the motorcycle. Once this panel is removed, you can loosen the screws that secure the ignition switch to its housing. After freeing it, you also need to disconnect the connector attached to it: this way, you can insert the new ignition switch, connect it to the connector, and secure it with the screws that were just removed. Finally, you can reposition the panel to check that everything is functioning properly.

Posted on 5 October 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the ignition switch of the Piaggio Vespa PX 125?
How do you replace the ignition switch of the Piaggio Vespa PX 125?
Vespa Px 125 In order to replace the ignition switch of the Piaggio Vespa PX 125, you need to loosen the screws that secure the inner panel of the front fairing: …
How to Replace the Rear Suspension on a Piaggio Vespa PX 125 - Lml Star 125
How to Replace the Rear Suspension on a Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 This brief guide outlines the steps to remove and replace the rear suspension on a Piaggio Vespa PX 125, as well as on an Lml Star 125. First, place …
How to Change the Rear Wheel of the Piaggio Vespa PX 125 - Lml Star 125
How to Change the Rear Wheel of the Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 In today's tutorial, you will see the procedure for removing and replacing the rear wheel of the Piaggio Vespa PX 125, as well as the Lml Star 125 an…

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos