Do it yourself
Frequently asked questions about cars and motorcycles

Model: Piaggio Vespa Et4
Part: Seat

In this video, we can see how to open the seat of a Vespa Piaggio - any model - without having the key on hand. Maybe we forgot it inside, and to open it, we will only need a piece of metal wire. We insert it under the seat on one side and near the lock, pulling it out in an arc on the other side. We take the two ends of the metal wire and pull towards us until the wire manages to open the simple lock that closes the seat. This way, we can lift it and retrieve our key that was left inside the storage compartment.


Posted on 6 March 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the spark plug of the Piaggio Vespa 150 ET4
How to replace the spark plug of the Piaggio Vespa 150 ET4
Vespa Et4 The following steps will show us how to disassemble and replace the spark plug of the Piaggio Vespa 150 ET4 scooter engine. First of all, we put the …
How do you remove the carburetor from the Piaggio Vespa ET4 125?
How do you remove the carburetor from the Piaggio Vespa ET4 125?
Vespa Et4 In order to remove the carburetor of the Piaggio Vespa ET4 125, you need to open the underseat compartment so that you can loosen the screws that sec…
Guide to replacing the starter motor of the Piaggio Vespa ET4 150
Guide to replacing the starter motor of the Piaggio Vespa ET4 150
Vespa Et4 Today's guide will show us how to disassemble and replace the starter motor of the Piaggio Vespa ET4 150 scooter, in simple steps. First, we put the …

How to replace the front headlight bulb of the Kawasaki ER-6F

These short and simple instructions will show us how to disassemble and replace the low beam bulb of the front headlight of the Kawasaki ER-6F motorcycle. First of all, we put the motorcycle on the central stand and start to remove the plastic bulb protection cap; then we disconnect the electrical connector of the bulb to remove it, as shown in the video. At this point, we install the new low beam bulb, of the right type and with the same attachment; we insert it in the correct direction and make the connection, finally verifying the correct operation!

Watch the video!


by ScegliAuto

More videos