Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the windshield of the Piaggio Vespa 150 LX

Model: Piaggio Vespa 150 Lx
Part: Windshield

Video tutorial

Today's step-by-step instructions will allow us to disassemble and replace the windshield or front visor of the Piaggio Vespa 150 LX scooter. First, put the center stand and start unscrewing the fixing screws on the windshield, attached to the two rods; then unscrew the lower screws of the brackets, in order to unhook and remove the windshield definitively, as shown in the video.

At this point, install the new visor, fixing it properly on the rods with the screws provided; make sure the gaskets are in good condition, avoiding vibrations.


Posted on 27 May 2025 by ScegliAuto


Related tutorials

How to Replace the Drive Belt on a Piaggio Vespa 150 LX
How to Replace the Drive Belt on a Piaggio Vespa 150 LX
Vespa 150 Lx This guide explains how to remove and replace the drive belt on a Piaggio Vespa LX 150, following the instructions below. First, place the central st…
How to disassemble the rear wheel of the Piaggio Vespa 150 LX
How to disassemble the rear wheel of the Piaggio Vespa 150 LX
Vespa 150 Lx The steps outlined in this guide will show us how to disassemble and replace the rear wheel and tire on the Piaggio Vespa 150 LX. First, we put the s…
Removing the Rear Wheel on the Piaggio Vespa ET4 - LX 150
Removing the Rear Wheel on the Piaggio Vespa ET4 - LX 150
Vespa 150 Lx In this video tutorial, follow the instructions to remove and replace the rear wheel on the Piaggio Vespa ET4, as well as the 125 and 150 LX. First, …

Replacing the Front Brake Pads on the Triumph Daytona 675

The following instructions will allow you to remove and replace the front brake pads on the Triumph Daytona 675. First, place the bike on a stand and begin undoing the fixing screws of the front brake caliper; apply pressure to the caliper piston to retract it, thus removing the old brake pads, as shown in the video. At this point, clean the caliper of any residual dirt, then install the new original brake pads; reattach the caliper to the disc, replacing the other brake pads in the same manner!

Watch the video!


by ScegliAuto

More videos