Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
You can replace the front brake pads on the Piaggio Vespa ET4 by loosening the nuts that secure the front wheel to the corresponding hub: you will then need to detach it from the fork so that you can access the brake disc and the corresponding caliper. By loosening the screws that secure the caliper to the disc, you can detach it and then remove the pin that secures the pads: these can now be removed from their seat to insert the new ones. You can reposition them on the disc to secure them and check that everything is functioning.

Posted on 8 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads on the Piaggio Vespa ET4?
How to Replace the Front Brake Pads on the Piaggio Vespa ET4?
Vespa Et4 To replace the front brake pads on the Piaggio Vespa ET4, start by loosening the bolts that secure the front wheel to the corresponding hub. Once the…
How to Replace the Fork Bearings on a Piaggio Vespa ET4
How to Replace the Fork Bearings on a Piaggio Vespa ET4
Vespa Et4 In this guide, we will provide instructions for removing and replacing the fork bearings on the front fork of a Piaggio Vespa ET4. First, place the s…
How to replace the headlight bulb in the Piaggio Vespa ET4 scooter?
How to replace the headlight bulb in the Piaggio Vespa ET4 scooter?
Vespa Et4 In this tutorial we can see how to replace the headlight bulb in the Piaggio Vespa ET4 scooter, an extremely simple and quick operation. First of all…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos