Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Piaggio Si
Part: Carburetor

This guide shows you how to remove and replace the carburettor on the Piaggio Si, as well as on the Ciao, Bravo, and Garelli. First, place the motorcycle on its centre stand and begin by removing the side cover of the engine, thus accessing the transmission and carburettor; then disconnect the clamp screw, followed by the fuel hose, as shown in the video. At this point, remove the throttle cable, thus taking out the carburettor; clean it or replace it directly, following the reverse procedure!

Updated on 31 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Rear Wheel and Hub of the Piaggio Si
How to Remove the Rear Wheel and Hub of the Piaggio Si
Si Today's guide shows how to remove and replace the rear wheel and its hub on the Piaggio Si, following the instructions below. First, unscrew the fast…
How to Remove or Replace the Front Wheel of the Piaggio Si - Garelli
How to Remove or Replace the Front Wheel of the Piaggio Si - Garelli
Si Today's guide will show you the steps to remove and replace the front wheel or tyre of the Piaggio Si, as well as the Ciao, Bravo, and Garelli. First…
How to Remove the Clutch Bell on a Piaggio Si
How to Remove the Clutch Bell on a Piaggio Si
Si In this video, you will see how to remove the clutch bell and clutch on a Piaggio Si 50cc in simple and quick steps. First, place your vehicle on the…

How to replace the engine oil in the Kawasaki Versys 1000?

As we can see in this tutorial, replacing the motor oil in the Kawasaki Versys 1000 is an extremely simple and fast operation. First of all, make sure that the engine is cool enough, then position a container under the motorcycle and, using a socket wrench, unscrew the drain plug. Wait for all the oil in the system to completely drain out, remove the lower front cover and unscrew the old filter. At this point, we can tighten the replacement, reassemble everything and pour in the new oil through the appropriate hole.

Watch the video!


by ScegliAuto

More videos