Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the front brake pads on the Vespa PX 125, loosen the screws that secure the wheel to its housing so that it can be completely removed. After removing the wheel, use an object to detach the cover located at the back of the caliper: removing this cover will allow you to slide out the pads inside so that they can be replaced with new spare parts. After removal, insert the new spare parts, reattach the caliper cover, and the corresponding wheel.

Updated on 16 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the front brake pads on Piaggio Vespa PX 125?
How to replace the front brake pads on Piaggio Vespa PX 125?
Vespa Px 125 You can replace the front brake pads on the Piaggio Vespa PX 125 by first removing the wheel from its housing: it can be detached from the bottom of …
How to Replace the Brake Pads on the Piaggio Vespa Px 125?
How to Replace the Brake Pads on the Piaggio Vespa Px 125?
Vespa Px 125 Start by removing the wheel and then take off the plastic cover on the brake caliper and detach the ring that secures the pin to which the pads are a…
How do you replace the front brake cable of the Piaggio Vespa PX 125?
How do you replace the front brake cable of the Piaggio Vespa PX 125?
Vespa Px 125 In order to replace the front brake cable of the Piaggio Vespa PX 125, you need to loosen the nut that secures the cable to the corresponding lever, …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos