Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Renault
  4. :
  5. Clio
  6. : Remove the front door panel on Renault Clio 3

Renault Clio - Video tutorial

Model: Renault Clio MK 3, Clio 3, Clio III - Years 2005-2013
Part: Door panel
Operation: Remove the front door panel on Renault Clio 3

Let's see in this short and simple video how to remove the front door panel on a Renault Clio third series. First of all we open the front door and start by removing the triangular plastic cover, levering the sides; after which we remove the plastic cover of the handle and unscrew the fixing screws that we find below as well as disconnect the electrical connector. At this point, after having removed all the screws of the panel, we are going to remove the loudspeaker, as in the video; then let's go and lever on the sides to release it: we just have to disconnect the handle cable!


Posted on 6 February 2024 by ScegliAuto



Guide to disassembling the Renault Clio door panel.
Renault Clio (2012-2019 / Clio IV, Clio 4, MK 4) Today's guide will show us the procedure for dismantling and replacing the front door panel of the Renault Clio. First, we open the front or rear doo
Replacing the door lock and door handle on the Renault Clio 3
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Let's find out in this guide how to remove and replace the external door handle, together with the driver's side lock, on the Renault Clio third seri
Replacement of the front speaker of the Renault Clio.
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Today's main instructions will show us how to disassemble and replace the front door speaker of the Renault Clio. First, we open the front door and b

Other guides that may interest you

    Frequently Asked Questions

    • Clio 1998-2005 - How to remove the door panel on Renault Clio 2? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos