Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Indicator Bulb on the Renault Master?

Model: Renault Master MK 2 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008
Part: Side marker bulb

See other generations:
Video tutorial

To replace the rear indicator bulb, access the inside of the load area to locate the small internal protective panel. This must be removed to disconnect the underlying connector.

This way, the bulb inside can be removed and replaced with a new spare part. After the replacement, reinsert the internal protective panel.

Then, switch on the ignition to check that the bulb functions correctly.


Updated on 12 August 2026 by ScegliAuto


Related tutorials

How to Replace a Bulb in the Renault Master 4
How to Replace a Bulb in the Renault Master 4
Renault Master (2024-2026 / MK 4, XDD) Discover how to independently replace a bulb in the Renault Master 4. Note that the vehicle used in the referenced video is a Renault Master 2, but t…
How to Replace the Rear Light Bulb on a Renault Master
How to Replace the Rear Light Bulb on a Renault Master
Renault Master (2010-2023 / MK 3) If you need to replace the rear light bulb on your Renault Master but don't know how to do it, carefully read the following guide and apply all the s…
How to Replace the Rear Light Bulb in a Renault Master II
How to Replace the Rear Light Bulb in a Renault Master II
Renault Master (1997-2010 / MK 2) Replacing the rear light bulb in your Renault Master II is quite simple. To complete the operation, carefully read the following guide and follow the…

How to Extract the Spare Wheel from a Mercedes Vito

The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle.

Watch the video!


by ScegliAuto

More videos