Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sherco Sef 300
Part: Oil filter

In order to replace the oil filter of the Sherco SEF 300, you will need to remove the corresponding cover located on the left side of the motorcycle, immediately behind the engine block cylinder. Once the cover is removed, you can use a special tool to remove the oil filter from its housing. At this point, you will need to oil the ends of the new filter so that it can be inserted. After insertion, you can close the filter housing with the corresponding panel, making sure everything is functioning properly.

Posted on 24 March 2025 by ScegliAuto

Video tutorial

Related tutorials

Engine Oil and Oil Filter Replacement for the Sherco SEF 300
Engine Oil and Oil Filter Replacement for the Sherco SEF 300
Sef 300 Here are the instructions on how to carry out the routine maintenance service by replacing the engine oil and oil filter on the Sherco SEF 300 enduro…
How to Change the Engine Oil on the Sherco SEF 300
How to Change the Engine Oil on the Sherco SEF 300
Sef 300 You can change the engine oil on the Sherco SEF 300 by loosening the screws that secure the skid plate located at the central bottom of the bike. Onc…
How to Change the Engine Oil on the Sherco SEF 300?
How to Change the Engine Oil on the Sherco SEF 300?
Sef 300 To change the engine oil on the Sherco SEF 300, access the central lower part of the bike where the oil drain plug is located. This can be unscrewed …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos