Do it yourself
Frequently asked questions about cars and motorcycles
To replace the piston on a Sherco ST 290, access the top of the engine. Disconnect all cables connected to the cylinder. Inside the cylinder, you will find the piston, which needs to be detached from its conrod by removing the retaining clip. Once the old piston is removed, insert the new one and secure it to the conrod with the retaining clip. After securing the component, reattach the cylinder using the appropriate screws and reconnect the cables.

Updated on 24 May 2026 by ScegliAuto

Video tutorial

Related tutorials

St 290 To dismantle the engine of the Sherco ST 290, you need to loosen the bolts securing the engine block to its housing: to free it, you will also need t…
St 290 To replace the clutch of the Sherco ST 290, you need to loosen the screws that secure the cover of the clutch housing: this will be located in the ce…
St 290 In order to replace the fork of the Sherco ST 290, first you need to remove the front wheel from its housing: you will need to start by loosening the…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos