Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to open the trunk of a Smart car

Model: Smart Smart 451 - Years 2007-2015
Part: Body

In this video, we can see how to open the trunk of a Smart '09 that was stuck, and also the doors would not close: at first it seemed that the problem was caused by the SAM control unit or fuses, but that was not the issue. It was not even the door actuator. Only by disconnecting the negative pole of the battery did the doors start working again; but not the rear hatch. Since the lower part cannot be opened without opening the upper glass, they had to drill a hole in the plastic to release the glass and access the lower part where they found switches that they tested and realized that the glass switch is working, while the hatch switch is not and therefore needs to be replaced: it can be found, for example, on Amazon with the code B0CLZ816LW at a price of 44.13 euros, with free delivery.

Posted on 14 June 2024 by ScegliAuto

Video tutorial

Related tutorials

How to open the trunk of a Smart car
How to open the trunk of a Smart car
Smart (2007-2015 / 451) Opening the trunk of a Smart car for those who have never dealt with this model may seem like a complicated operation to perform, but in reality it i…
How to replace the cabin air filter of the Smart Fortwo.
How to replace the cabin air filter of the Smart Fortwo.
Smart (1998-2007 / 450) The air filter of the Smart Fortwo model 450 is located inside the trunk under the carpet cover. To replace the filter, we need to open the trunk and…
How to open the boot lid of the Smart Fortwo
How to open the boot lid of the Smart Fortwo
Smart (2007-2015 / 451) Let's see in this short and simple guide the instructions that will allow us to open the rear door of the Smart Fortwo. First of all, let's move to t…

Other guides you may be interested in

Timing Belt Replacement on Audi Q5

The timing belt on the Audi Q5 has reached its mileage limit, so what should you do? Let's go through the removal of the belts on the Q5. Open and lift the hood of the engine, then remove the engine soundproofing panel. Once these steps are completed, remove the plastic covers of the belts located on the left side of the engine. Loosen the second tensioner and slide the belt out of its seat. After installing the new belt, use a wrench to install the tensioner pulley, and tighten it until the belt has the correct tension (install both belts). Reinstall the covering plastics. Start and test the Audi Q5 engine.

Watch the video!


by ScegliAuto

More videos